Videos

If your lifter has VPFS625 vacuum pads (#58383), this video takes you step-by-step through the process of replacing its inserts (#49726). View Product Page

Instruction video for installing DC3 UPDATE KIT for MRT4, MRTA8, and MRTALP Series vacuum lifters.

How to rebuild Dynaflow single head and dual head vacuum pumps.

Step-by-step process for installing 59906 Remote Control System on a MRTA8-DC3 Vacuum Lifter. Visit our website to download the instructions.

Watch the benefit of vacuum reserve tanks as they increase battery run-time by reducing pump cycles needed to maintain vacuum.

Check valves are a common source of vacuum leaks in WPG vacuum lifters. The location of the check valve may vary depending on the make or model of the lifter. Begin by removing the hose connected to the check valve, followed by the associated hose fitting. Each check valve has an arrow on the side indicating the direction of airflow; note the arrow to ensure correct reassembly. Disconnect the check valve from the hose fitting and dispose of the old valve. Remove any excess thread sealant from the threads to be reused, wiping outward to prevent sealant from entering the fitting. Install the new check valve in the same orientation as the original, as indicated by the airflow arrow. Apply a small bead of thread sealant to the threads, keeping it away from the first one or two threads to avoid introducing sealant into the check valve. Reattach the hose fitting to the check valve. Apply thread sealant to the opposite end of the check valve using the same method and connect the remaining fitting. Do not overtighten, as the thread sealant will provide a secure seal. Trim a small portion from the end of the hose if necessary to ensure a clean, tight connection, then reconnect the hose to the hose fitting.

Overview of a digital multimeter and its primary functions, including measuring AC and DC voltage, current, resistance, and continuity. Demonstrates common applications for testing batteries, outlets, wires, and basic electronic components, along with general safety considerations.

How to replace the sealing rings in a Gast N70 Wobble Piston Type - 4 SCFM [113 liters/minute] - AC Vacuum Pump

How to replace gaskets in a Diaphragm Type Vacuum Pump - 1 SCFM [28 liters/minute] - 12 VDC